Henkel LOCTITE® EA9309.NA™ AERO Epoxy Paste Adhesive
You'll really get stuck on SkyGeek's high-quality products, low prices and great customer service. You'll also get stuck on this Henkel Hysol® EA9309NA epoxy paste adhesive. Actually, we hope you don't get stuck to it yourself. It's really meant to stick to metal, glass, plastics and wood. This premium Hysol 9309 adhesive is made with a beige translucent paste and a red liquid curing agent (part A and part B). The Hysol EA9309NA adhesive bonds are extremely strong yet flexible, and they resist salt spray, water and most common aircraft fluids. It also provides exceptional peel strength to aluminum.
You can trust us for the best selection of adhesives, sealants, tapes, fluids, oils, lubricants and other "consumables" for the aerospace industry, available at low prices.
Hysol EA9309NA HandlingMixing - This product requires mixing two components together just prior to application to the parts to be bonded. Complete mixing is necessary. The temperature of the separate components prior to mixing is not critical, but should be close to room temperature (77° F/25° C).
Note: Volume measurement is not recommended for structural applications unless special precautions are taken to assure proper ratios.
Pot Life (450 gm mass) 40 minutes Method - ASTM D2471 in water bath.
Mixing - Combine Part A and Part B in the correct ratio and mix thoroughly. THIS IS IMPORTANT! Heat buildup during or after mixing is normal. Do not mix quantities greater than 1 pound/ 450 grams as dangerous heat buildup can occur causing uncontrolled decomposition of the mixed adhesive. TOXIC FUMES CAN OCCUR, RESULTING IN PERSONAL INJURY. Mixing smaller quantities will minimize the heat buildup.
Applying - Bonding surfaces should be clean, dry and properly prepared. For optimum surface preparation consult the Hysol Surface Preparation Guide. The bonded parts should be held in contact until the adhesive is set. Handling strength for this adhesive will occur in 12 hours @ >77° F/25° C, after which the support tooling or pressure used during cure may be removed. Since full bond strength has not yet been attained, load application should be small at this time.
Curing - This adhesive may be cured for 3 - 5 days @ 77° F/25° C to achieve normal performance. Accelerated cures up to 200° F/93° C (for small masses only) may be used as an alternative. For example, 1 hour @ 150° F/66° C will give complete cure.
Cleanup - It is important to remove excess adhesive from the work area and application equipment before it hardens. Denatured alcohol and many common industrial solvents are suitable for removing uncured adhesive. Consult with your supplier's information pertaining to the safe and proper use of solvents.
Uncured Adhesive Properties