Sherwin Williams U00361-10CC Jet Glo Conventional Vestal White Touch Up BurstSeal Pak - 10CC Pak

Jet Glo Vestal White CM0570545 is a high-performance, multi-component polyester urethane, designed for exterior use on high performance general aviation, business jet, and commercial aircraft. Jet Glo® has outstanding high-gloss appearance, durability and Skydrol fluid resistance with Sherwin-Williams Aerospace primers.

Advantages:

Jet Glo should be applied to a surface that has been coated with an approved, properly prepared and applied Sherwin-Williams Aerospace primer system.

For best adhesion of trim colors to the cured urethane base coat, a thorough scuff sanding is recommended. Scuff sanding and cleaning will assure long-term durability and adhesion of the applied coating.

Mixing Instructions

The New BurstSeal Paks make mixing a breeze! No mess, no waste! Massage each component for 5 minutes before admixing.

Admix by Volume (Parts pre-measured in Pak for you):

1 Part - Jet Glo Vestal White CM0570545
1 Part - Jet Glo Hardener CM0578520

Push both parts together with fingers breaking middle seal of package. Continue to massage contents for 5 minutes for optimum application performance.

Admixed product should be allowed a 30-minute induction time for optimum application performance.

No need to filter because of the closed mixing process.

Application

This product should be applied using a hand brush

Drying Schedule

Dry times are based on the dry film thickness of 2-3 mils (50-75 microns).

Air Dry Times (75°F / 25°C, 50% RH) To Tape: Unaccelerated - 16-18 Hours, Accelerated - 2-3 Hours Recoat Time: Max. 24 Hours

NOTE: Lower temperatures, heavy film thickness, improper activator range selection and poor air movement will extend the dry time.

Equipment Cleanup

Use clean Ketone–type solvents such as CM0110308 MEK. Do not allow material to cure inside equipment.