Prist Hi-Flash Hi-Flo Anti-Icing Fuel Additive - 5 Gallon Pail

Why should you use a fuel additive?
All turbine aircraft fuels contain some dissolved water. It cannot be extracted because it does not exist as particulate water. When an aircraft rises to flight altitude, the fuel cools and its capacity to retain dissolved water is reduced. Some of the dissolved water separates out as discrete water that can form into ice crystals or remain as a supercooled liquid. When supercooled water strikes a tubing bend or a filter, it can freeze quickly and block a fuel line or filter. If suspended ice crystals are present, they can also block a filter. Prist Hi-Flash anti-icing aviation fuel additive controls icing in aircraft fuel by depressing the freezing point of water.

Controlling Fuel System Icing
Prist Hi-Flash additive has limited solubility in jet fuel, but is completely soluble in water. When dissolved water separates from the fuel, some amount of Prist Hi-Flash additive quickly leaves the fuel and preferentially dissolves in the water. This depresses the water's freezing point. As the fuel gets colder, and more water particles appear, more Prist Hi-Flash additive leaves the fuel and enters the water, and your aircraft's fuel lines stay clear.

Fully Authorized
Prist Hi-Flash anti-icing aviation fuel additive is authorized by the United States Armed Forces under Military Specification Mil-DTL-85470(B), and by the ASTM under Standard D4171 for use in civilian jet fuels as a fuel system icing inhibitor. As part of its ASTM approval process, the formulation of Prist Hi-Flash additive was reviewed and approved by turbine engine and turbine aircraft airframe manufacturers worldwide. Prist Hi-Flash additive is recommended for every refueling at a dosage rate of .10% minimum to .15% maximum by volume.

Handling and Storage
Prist Hi-Flash aviation fuel additive should be handled as a combustible liquid and stored away from direct sunlight and other sources of heat. The flammable limits of its vapor range from 1.2% to 22% in the air.

Prist Hi-Flash additive should be protected from contact with oxidizing agents, including long-term contact with the air, as it can combine with oxygen to form explosive peroxides, and since exposure to the atmosphere may cause it to absorb moisture.

Carbon dioxide, alcohol-type foam, or dry chemicals should be used for extinguishing a Prist Hi-Flash fuel additive fire, since water may cause frothing.

Health Hazards
Acute— Diethylene glycol monomethyl ether (DEGMME), the primary ingredient of Prist Hi-Flash aviation fuel additive, is an eye and mucous membrane irritant, a nephrotoxin and central nervous system depressant. DEGMME can be absorbed through skin in toxic amounts when contact is extensive and prolonged; it is toxic by skin absorption. And it may cause pain and transient injury to eyes.

DEGMME may cause irritation to the mucous membranes. Due to the low volatility of this material, it is believed to present no unusual hazards from inhalation when handled at room temperature. The oral toxicity of DEGMME is low.

Chronic— Fetal development abnormalities and effects on fertility have been reported to occur from prolonged ingestion by rats, mice and rabbits. For additional information, please consult the MSDS for this product.