Magnaflux SKD-S2 Spotcheck Non-Aqueous Developer - 16 Oz. Aerosol Can

SKD-S2 features a flash point of two degrees Fahrenheit and a density of 7.3 pounds per gallon. This developer has non-corrosive properties and boasts 12 compliances, such as AMS, MIL and Boeing specifications. Purchase the military and commercial specified Magnaflux SKD-S2 with confidence. Use Magnaflux Spotcheck SKD-S2 developer in conjunction with your aviation penetrant indication products, all available at budget-friendly prices that any aviator will love at SkyGeek!

1 aerosol can (16 ounce by volume) approximately 65 square feet

On standing, developer particles will settle out of suspension and must be re-suspended before applying. SKD-S2 should be applied by spraying only, as dipping or brushing will cause excessive solvent action on the penetrant in discontinuities. SKD-S2 may be applied by aerosol, or conventional spray gun. Developers should be applied only after the test surface has been cleaned of excess penetrant, and the cleaning medium (solvent such as SKC-S or SKC-HF or water) has been dried off. Non-aqueous developers should be sprayed in thin even layers, which just wet the surface. Too wet a spray will cause excessive bleeding and running of indications; whereas too dry a spray will result in slow indication development as well as possible loss in overall sensitivity due to limited solvent action. The coating should be a relatively thin even white coating. SKD-S2’s unique formula permits a thin coating to hide surface blemishes, which could interfere with indication interpretation. A thick coating is not required for this effect and is undesirable as masking of indications could result. SKD-S2 will appear as red lines and porosity as spots. A general reddish color or pink developer film indicates incomplete removal of surface penetrant.