M-D Building Products 92379 SmartTool™ 24" Digital Level - Inch/Feet

This 24" long SmartTool Digital Level is based around an electronic module that displays angles over a full 360° range with a resolution of 0.1°. Can be used as a level, plumb or clinometer, and allows you to find level and plumb in two ways. The high precision digital display provides amazing accuracy within 1/10 of a degree. SmartTool can quickly tell you what the angle is or what the angle needs to be by quickly identify any angle in degrees, percent slope or pitch (millimeters of rise or fall per linear meter). For quick reference you can use the sensitive acrylic bubbles, and for high precision projects, the digital display provides amazing accuracy within 1/10 of a degree. When you are not dealing with level or plumb, SmartTool quickly tells you what the angle is and what the angle needs to be by quickly identify any angle in degrees, percent slope or pitch (millimeters of rise or fall per linear meter).

Read in Degrees
Set saw blade angles to a fraction of degree accuracy with SmartTool. Assure there is no gap when you join 2 cuts together with .1 degree accuracy. You can easily duplicate a stair angle for setting handrails and never again will you be measuring top and bottom to make sure stair treads and rails are parallel.

Percent Slope and Pitch
In the percent slope mode, the SmartTool allows you to read angles to meet requirements for sewer connections, ADA ramps, and grading. And showing compliance is merely a matter of pointing to the display. SmartTool also gives you roof pitch readings -- in inches of rise per foot of run -- right on the display. No two-handed measurements, no conversion calculations, and no mistakes.

Listen and Level Audio Feature
Have tasks where you really can't see the SmartTool but need instant feedback? Then turn on the audio beeper. When turned on with a single button, SmartTool lets you hear when your task is at level or plumb. This can be great when shimming projects, leveling buildings, pool tables or other projects where you need immediate feedback but are not in a position to see the display. This can leave your hands free to adjust, nail, or screw the project in place when you hear the beep telling you it is where you want it.

Hold
The hold button makes it easy to measure in areas where the digital display is not visible. Take the measurement, push the hold button, and then bring the SmartTool in front of you to see your reading.

The unit is housed in environmentally sealer polycarbonate housing, and the 9 volt battery provides up to 120 hours of continues use.

Controls include:

• ON/OFF - automatic shut-off if left idle for 6 minutes
• HOLD - freeze or unfreeze display readings
• LISTEN & LEVEL AUDIO - beeper will sound at level and plumb
• CALIBRATE - simple two-step calibration procedure (recommended once per day)
• Deg.,%,IN/FT - select display units
• UP/DOWN ARROWS - show direction of tilt to reach level or plumb
• LOW BATTERY - low 9V battery indicator