AC Tech 240B-1/2 Quick Cure Fuel Tank & Fuselage Sealant - AMS-S-8802B1/2

1. Holding the cartridge, grasp the dasher rod and pull back approximately one inch


2. Insert the ramrod into the hollow of the dasher rod, break the piston loose, and inject about 1/3 of the contents into the cartridge

   Note: Do not inject all of catalyst in one location. Distribute evenly throughout base material



3. Repeat steps 2 and 3 until all the contents of the rod are emptied into the cartridge. Remove the ramrod


4. Mix for the required number of strokes (hand mixing) or for the required amount of time (machine mixing) indicated in the kit instructions


5. When mixing is complete, remove bottom cap


6. Pull the dasher rod back to the neck of the cartridge, grasp the cartridge firmly at the neck, unscrew the dasher rod and remove


7. Screw the nozzle into the cartridge, insert into the extrusion gun and use as required. For hand extrusion, press the used dasher rod against the plunger to force the material from the cartridge

Storage

The shelf life of AC-240 Class B is 9 months from date of packaging, when stored at temperatures below 80 degrees F in its original container.

Mixed AC-240 Class b may be stored under refrigeration as follows: 15 days at -10 degrees F, 30 days at -40 degrees F.

It is important to remember that freezing, storing and thawing procedures reduce application life. Also, frozen storage will reduce application life by varying amounts depending on the storage temperature and length of storage time. All aspects of storage, freezing and thawing should be planned carefully and it is not recommended to mix and freeze with less than half an hour application time.

Health and Safety Precautions

AC-240 Class B sealant is safe to use and apply when recommended precautions are followed. Before using this product, read and understand the Material Safety Data Sheet (MSDS), which provides information on health, physical and environmental hazards, handling precautions and first aid recommendations. An MSDS is available on request. Avoid overexposure. Obtain medical care in case of extreme overexposure.

Typical Physical and Application Properties

Application Life and Cure Time

B-1/4

B-1/2

B-2

B-4

*Application life refers to the length of time the mixed compound remains at a consistency suitable for application with spatula or caulking gun. Application life is always measured as a standard temperature of 77 degrees F with a relative humidity level of 50%. In general, for every 20 degree F rise in temperature, the application life is halved; and for every 20 degree F drop, it is doubled. High humidity levels during the mixing process will shorten application life.

**Tack-free time is the length of time after which a mixed sealant will no longer tightly adhere to L-LP-690 standard low density polyethylene film.

***Cure time is defined as the length of time it takes AC-240 Class B sealant to reach 30A hardness. It depends on three factors: remaining application life, temperature and relative humidity. The temperature/humidiity factors for application life also apply to curing. To accelerate the curing process, apply heat up to (but not more than) 140 degrees F.

Typical Physical and Performance Properties of Cured Compound After 14 Days at 77 degrees F / 50% Relative Humidity when tested per AMS-S-8802